Navigation
Records in this category
- After launching the software, LightScribe Print icon does not appear in the toolbar.
- The unit loads multiple discs at the same time, fails to unload discs, or discs are jammed
- When labeling the first disc, the program stops and the LS_Dialog window does not appear.
- The unit loads multiple discs at the same time, fails to unload discs, or discs are jammed
- When labeling the first disc or after a number of discs, the program does not respond and LS_Dialog does not appear.
- When labeling the first disc or after a number of discs, LS_Dialog error window or the program error window appears.
- When labeling discs, a great number of unlabeled discs are ejected to the failed disc bin.
- LightScribe labels only half of the disc and ejects the disc to failed disc bin.
- LS dialog opens, jumps from 0% to 83% and closes again.
- Disc failure rate is high
- Initialization fails after launching the software but the unit is turned on.
- Initialization fails after launching the software but the unit is turned on.
- After launching the program a pop-up window appears showing error message.
Tags
PC-Connected » Xymba USB DiscFlip
ID #
After launching the program a pop-up window appears showing error message.
Reason:
Finished Disc Bin is not in position on BW7160/XB47.
Output Ramp is not open on BW7161/XB57.
Recommendation:
1.Check if the finished disc bin in sitting correctly in the XB47.
2. Check if the output ramp is open on the XB57.
Tags: disposition, error message, finished disc bin, launch, ramp
Related entries:
- After launching the program a pop-up window appears showing error message.
- After launching the program a pop-up window appears asking for the Serialnumber.
- After launching the program an error pop-up window about the setting of the "Disc Inner Diameter" appears.
- Why does QQcatcher pop up a window asking whether to continue the process?
- When labeling the first disc or after a number of discs, LS_Dialog error window or the program error window appears.
Last update: 2009-11-24 04:47
Author: Acronova Tech Support
Revision: 1.1
You cannot comment on this entry