Navigation
Records in this category
- After launching the software, LightScribe Print icon does not appear in the toolbar.
- The unit loads multiple discs at the same time, fails to unload discs, or discs are jammed
- When labeling the first disc, the program stops and the LS_Dialog window does not appear.
- The unit loads multiple discs at the same time, fails to unload discs, or discs are jammed
- When labeling the first disc or after a number of discs, the program does not respond and LS_Dialog does not appear.
- When labeling the first disc or after a number of discs, LS_Dialog error window or the program error window appears.
- When labeling discs, a great number of unlabeled discs are ejected to the failed disc bin.
- LightScribe labels only half of the disc and ejects the disc to failed disc bin.
- LS dialog opens, jumps from 0% to 83% and closes again.
- Disc failure rate is high
- Initialization fails after launching the software but the unit is turned on.
- Initialization fails after launching the software but the unit is turned on.
- After launching the program a pop-up window appears showing error message.
Tags
PC-Connected » Xymba USB DiscFlip
Initialization fails after launching the software but the unit is turned on.
Reason 1:
Problem with the USB connection between PC and the unit.
Recommendation 1:
1. Check USB connection
2. Change USB cable
3. Check if USB slot is USB 2.0 Hi-Speed spec
Reason 2:
SATA USB bridge board is defected.
Recommendation 2:
1. Turn on the devide manager to see if the disc autoloader and the USB RW drive are online. If not, there is a problem with the USB connection. Check if the USB cable, USB slot of the unit and PC's USB slot are functioniong.
2. Turn on the devide manager to see if the disc autoloader and the USB RW drive are on-line.If the autoloader is online but the RW drive isn't, reboot the PC and the unit and try again.
3. If the problem still exist after several try-outs, contact your supplier.
Tags: initialization, launch, software, USB connection
Related entries:
- Initialization fails after launching the software but the unit is turned on.
- Why does QQripper fail the initialization of autoloader?
- The unit is connected and turned on, but after launching QQripper, a pop up window displays "No Device".
- After launching the QQboxx, the program initializes continuously and does not stop.
- Data to Disc verification always fails.
Author: Acronova Tech Support
Revision: 1.2
You cannot comment on this entry